How to correctly connect alumina ceramic roller

Time:2018/6/25 17:25:52 Click on:

There are many ways to connect the alumina ceramic roller, according to the specific conditions of the ceramic tube itself, the following describes a simple connection.

The first thing to do is to break the pipe. The pipe must be cut off according to the required length. Then we must pay attention to the time when the pipe is broken. If the force is too large, otherwise it may cause the ceramic riser to be out of round; It is to remove burrs. When the pipe is cut off, the burrs must be removed, otherwise the sealing ring will be cut.

Then mark the mark. In order to fully insert the ceramic riser into the socket of the tube, at this time, certain marking lines must be drawn on the tube end; then, the sealing ring should be correctly installed in the groove of our ceramic riser. . For this, we need to insert the tube into the tube socket and wait for crimping.

Finally, what we need to do for the connection of alumina ceramic roller is crimping and inspection. When crimping, pay attention to the convex part of the tube, and place it in the concave groove of the mold. For the jaw and tube axis, it must be vertical. After the above steps are completed, we must pay attention to the use of special gauges to check the size of our crimps.

alumina ceramic roller ， fused silica roller for tempering furnace ，high temperature alumina ceramic roller ，Company website： http://www.ceramicroller.net/ 

• Previous：Alumina Ceramic Roller Is A New Ceramic
• Next：Fused Silica Roller For Tempering Furnace Packaging And Transportation